Water Level Controls Sensor Probe - The Boiling Point

On this episode of The Boiling Point Jude Wolf will discuss the advantages of probe type water level controls over the float type. He will also share the various ways the probe type water level controls can be mounted externally to boilers and some of the recommendations he suggests to keep your probe type water level control working efficiently.

Tip:
Do you know the proper length of your probe? You should remove the probe type water level control during your open and close. Use sand paper to clean off any rust build up. Measure the length of your probe and use a sharpie to document the length on the outside of the boiler for the next time you need to replace it.

Need a part? Click here for all of our probe products: https://goo.gl/7vGLxn

Key Terms:
water level sensor probe
boiler probe
boiler level control
low water cut off steam boiler
boiler controls
boiler maintenance
warrick relays Thank you for visiting our YouTube page. Ware Boilers’ videos are intended for promotional purposes only. Please contact our boiler professionals via https://www.wareinc.com/ with specific questions or repair needs. You should not attempt any boiler repair or modification without first consulting with a licensed contractor and the manufacturer. Ware Boilers does not warrant the accuracy, completeness, or usefulness of information available on this YouTube page. Nothing contained in or provided in any of Ware Boilers’ videos is intended to constitute advice or to serve as a substitute for a licensed contractor’s inspection or manufacturer specifications. Any reliance you place on such information is strictly at your own risk.